1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM group).
|
3. |
Disconnect the injector connector (A).
|
4. |
Remove the installation bolt (B), and then remove
the sensor from the cylinder block.
|
Installation
1.
Installation is the reverse of removal.
...
To keep locks from freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine
into the key opening. If a lock is covered with ice, squirt it with an approved
de-icing fluid to remove the ice. If ...
Heated Oxygen Sensor (HO2S). Specifications
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2 ...