Hyundai Accent Manuals

Hyundai Accent: Removal - Injector. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Injector. Repair procedures / Removal

In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the delivery pipe & injector assembly (Refer to "Delivery Pipe" in this group).
4.
Remove the connector (A) and the fixing clip (B), and then separate the injector from the delivery pipe.

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Installation
1. Combustion seal 2. Rubber washer 3. Support disc 4. O-ring ...

See also:

Output Speed Sensor. Schematic Diagrams
Circuit Diagram ...

Power outlet
The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engin ...

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn si ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com