1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Disconnect the purge control solenoid valve connector
(A).
|
3. |
Disconnect the vapor hoses (B) from the purge control
solenoid valve.
|
4. |
Remove the valve after removing the bolt (C).
|
Heated Oxygen Sensor (HO2S). Specifications
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2 ...
Components and Components
Location
Components
1. HECU module
2. Front wheel speed sensor
3. Rear wheel speed sensor
4. Yaw rate & Lateral G sensor
5. Steering angle sensor
6. ABS Warning l ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...