1. |
Turn the ignition switch OFF and disconnect the negative
(-) battery cable.
|
2. |
Disconnect the accelerator position sensor connector
(A).
|
3. |
Remove the installation nuts (B), and then remove
the accelerator pedal module.
|
Room Lamp. Repair procedures
Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the
room lamp connector (A).
...
Removal
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Turn the steering wheel so that the ...
Installation
•
Install the component with the specified
torques.
•
...