In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
3. |
Remove the intake manifold (Refer to "Intake And
Exhaust System" in EM group).
|
4. |
Disconnect the injector connectors (A) and the rail
pressure sensor connector (B).
|
5. |
Remove the high pressure fuel pipe (C).
|
6. |
Remove the engine oil gauge.
|
7. |
Remove the installation bolt (D), and then remove
the delivery pipe and injector assembly from the engine.
|
Interior Trim. Repair procedures
Replacement
Door Scuff Trim Replacement
[Sedan]
•
Put on gloves to protect your ...
Parking brake
Applying the parking brake
To engage the parking brake, first apply the foot brake and then pull up the
parking brake lever as far as possible without pressing the release button.
In addition it ...
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification:
Refer to “Waveform”
...