Hyundai Accent Manuals

Hyundai Accent: Removal - Clutch Pedal. Repair procedures - Clutch System - Clutch SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Pedal. Repair procedures / Removal

•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Disconnect the ignition lock switch connector (A) and clutch switch (B).

2.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer.
3.
Remove the clutch pedal mounting nuts (A-3ea, B-1ea).
Tightening torque:
(A) 12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
(B) 18.6 ~ 23.5 .Nm (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

4.
Remove the clutch pedal assembly.

Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measu ...

Installation
1. Installation is the reverse of removal. ...

See also:

Disassembly and Reassembly
1. Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary. 2. Loosen the lock nut. ...

Input Speed Sensor. Description and Operation
Description Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critic ...

Head Lamps. Components and Components Location
Component 1. Head lamp assembly lens & housing 2. Head lamp (High/Low) 3. Dust cap 4. Turn signal lamp ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com