1. |
Remove the following items;
|
2. |
Disconnect the vehicle speed sensor connector (A).
|
3. |
Remove the back up lamp switch connector (B).
|
4. |
Remove the ground cable from transaxle (A).
|
5. |
Disconnect the shift cable bracket bolts (B-3ea) after removing
the washer and pin (A).
|
6. |
Remove the tube bracket bolt (A).
|
7. |
Remove the transaxle upper mounting bolt (B-2ea) and the start
motor mounting bolt (A-2ea).
|
8. |
Remove the hood assembly.
(Refer to "Exterior (hood)" in BD group.)
|
9. |
Remove the cowl top cover.
(Refer to "Interior(cowl top cover)" in BD group.)
|
10. |
Remove the wiper motor.
(Refer to "Windshield Wiper motor" in BE group.)
|
11. |
Remove the cowl complete assembly panel (A).
|
12. |
Using the engine support fixture (Support SST No.: 09200-2S200,
Adapter SST No.: 09200-2S100, Beam SST No.: 09200-38001/3N000), hold
the engine and transaxle assembly safely.
|
13. |
Remove the mounting cover (A).
|
14. |
Remove the transaxle support mounting bracket bolts (A-2ea).
|
15. |
Remove the transaxle support mounting bracket (A).
|
16. |
Remove the under cover (A).
|
17. |
Remove the drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
|
18. |
Remove the clutch release cylinder assembly (B) after removing
the nuts (A-2ea).
|
19. |
Remove the roll rod support bracket (C) after removing bolt (A,B).
|
20. |
Remove the drive shaft cover (A).
|
21. |
Remove the brackets (A).
|
22. |
Remove the lower mounting bolts (A-3ea, B-2ea) of lower part of
the transaxle, and the left side cover and remove the transaxle assembly
by supporting it with a jack.
|
Specifications
Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
22.0 ~ 26.0 [20°C(68°F)]
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Specifications
Description
Specifications
Limit
General
Type
In-line, DOHC
Number of cylinders
...