1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
4. |
Remove the valve body cover (B).
|
5. |
Remove thd air breather hose (A).
|
6. |
Remove the plate and the detent spring (A) after removing the
bolt.
|
7. |
Remove the bolt (3ea) after disconnecting the solenoid valve (B)
connector and the oil temperature sensor connector (A).
|
8. |
Remove the valve body assembly (A).
|
Removal
•
Do not spill brake fluid on the vehicle;
it may damage the paint if brake fluid does contac ...
Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...
Inhibitor Switch. Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control
gear setting signals.
...