Hyundai Accent Manuals

Hyundai Accent: Removal - Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures / Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the air breeder hose (A).
5.
Remove the valve body cover (B).
Tightening torque :
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

6.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

8.
Remove the torque converter control solenoid valve (A).

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

Installation
1. Installation is the reverse of removal. • ...

See also:

Removal
Rear Disc Brake Type The parking brake cables must not be bent or distorted. This will lead to stiff operation and ...

Valve Body. Components and Components Location
Components Location 1. PCV adjust screw 2. Solenoid valve 3. Oil temperature sensor 4. Accumulator 5. Low & reverse brake(LR/B) pressure flow hole 6. Und ...

Installation
• Install the component with the specified torques. • ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com