Hyundai Accent Manuals

Hyundai Accent: Removal - Inhibitor Switch. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch. Repair procedures / Removal

1.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
2.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
3.
Remove the air cleaner assembly.
(Refer to "Intake manifold" in EM group.)
4.
Remove the shift cable mounting nut (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 Kgf.m, 5.7 ~ 8.6 lb-ft)
5.
Disconnect the inhibitor switch connector (A).
6.
Remove the manual control lever (B) and the washer after removing a nut (A).

When installing, affix the manual control lever and the inhibitor switch with Ø5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
7.
Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.

Inhibitor Switch. Repair procedures
...

Installation
1. Installation is the reverse of removal. ...

See also:

Input Speed Sensor. Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Inspection
Driver Door Lock Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to ...

Parts
When replacing parts, use HYUNDAI genuine parts. ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com