Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front bumper. (Refer to the Body group - "Front bumper")

3.	Remove the washer reservoir. (Refer to the Body Electrical group - "Washer motor") [Right side only]

4.	Remove the front impact sensor mounting bolt (A).

5.	Disconnect the front impact sensor connector (B).

6.	Remove the front impact sensor.

Front Impact Sensor (FIS). Repair procedures

...

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

See also:

Replacement
1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Service Adjustment Procedure
Oil level Check A check of ATF level is not normally required during scheduled services. If an oil leak is found, ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3. Set the temperature control to the desired positio ...

Hyundai Accent Manuals

© 2011-2024 Copyright www.hamanual.com