Inspection
1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Disconnect the negative battery terminal.
|
2. |
Remove the rear trunk lid trim, and then remove the trunk lid
switch from the actuator.
|
3. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Remove the steering column upper (A) and lower (B) shrouds after
removing 3 screws.
|
2. |
Disconnect the connector (6p) from the door warning switch.
|
3. |
Check for continuity between the terminals in each position according
to the table.
|
Fuel Tank Pressure Sensor
(FTPS). Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative
emission control system and is installed on the fuel tank, the fuel pump, or
the canister. It checks the purge ...
Installation
•
Install the component with the specified
torques.
•
...
Instrument cluster
Type A
Type B
1. Tachometer
2. Turn signal indicators
3. Speedometer
4. Engine temperature gauge
5.Warning and indicator lights
6. Fuel gauge
7. Odometer/Trip computer
❈ The actual ...