Inspection
1. |
After disconnecting the vapor hose from the PCV valve,
remove the PCV valve.
|
2. |
Reconnect the PCV valve to the vapor hose.
|
3. |
Run the engine at idle, then put a finger over the
open end of the PCV valve and make sure that intake manifold vacuum
can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation,
if operating correctly clean or replace the vapor hose.
|
Seat Belt Buckle Switch (BS). Components and
Components Location
Components
...
Installation
•
Install the component with the specified
torques.
...
Manifold Absolute Pressure
Sensor (MAPS). Specifications
Specification
Pressure
[kPa (kgf/cm², psi)]
Output Voltage (V)
20.0 (0.20, 2.9)
0.79
46.7 (0.47, 6.77)
1.84
...