Hyundai Accent Manuals

Hyundai Accent: Repair procedures - Manual Transaxle System - Manual Transaxle System (M6CF1)Hyundai Accent: Repair procedures

Hyundai Accent RB (2010-2018) Service Manual / Manual Transaxle System (M6CF1) / Manual Transaxle System / Repair procedures

Inspection

Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil filler plug (A) with a new washer.
3.
Check level with finger.
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install the filler plug with a new gasket.
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)
Manual Transaxle Oil Replacement
1.
Park the vehicle on a level ground and stop the engine.
2.
Drain the manual transaxle oil after loosening the drain plug (A).
3.
Intall the drain plug with a new gasket
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)
4.
Add new oil through the filler plug hole and, fill it just below the plug opening.
Standard oil: SAE 75W/85, API GL-4
Oil capacity: 1.8 ~ 1.9L (0.48 ~ 0.50 U.S.gal., 1.90 ~ 2.01 U.S. qt., 1.58 ~ 1.67 lmp qt.)

Manual Transaxle System
...

Manual Transaxle. Components and Components Location
Components 1. Transaxle support bracket 2. Control shaft complete 3. Back up lamp switch 4. Speedmeter ...

See also:

Intake Air Temperature Sensor (IATS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between th ...

Circuit Diagram - ESC (3)
...

Push-starting
Your manual transaxle-equipped vehicle should not be push-started because it might damage the emission control system. Vehicles equipped with automatic transaxle cannot be push-started. Follow the ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com