|
1. |
After loosening the mounting screws, then remove the tail gate
trim (A).
|
2. |
Installation is the reverse of removal
|
1. |
Remove the tail gate trim.
|
2. |
Disconnect the tail gate latch rods (A).
|
3. |
After loosening the mounting bolts, then remove the latch assembly
(A).
|
4. |
Disconnect the tail gate latch connector (A).
|
5. |
Installation is the reverse of removal
|
1. |
Remove the tail gate trim.
|
2. |
Disconnect the key holder rod (A), then loosen the key holder
(B) mounting bolts and remove.
|
3. |
Installation is the reverse of removal
|
1. |
Remove the tail gate trim.
|
2. |
Disconnect the outside handle rod (A).
|
3. |
After loosening the mounting nuts, then remove the outside handle
(A).
|
4. |
Installation is the reverse of removal
|
|
1. |
Using a screwdriver (A), lift up slightly the socket clips (B)
of both ends on the lifer (D), and then remove the lifter from the bracket
(C).
|
2. |
Push the socket of the lifter into the bracket for installation.
|
|
1. |
Remove the tail gate weatherstrip (A).
|
2. |
Installation is the reverse of removal.
|
Headlamp delay
If you turn the ignition switch to the ACC or OFF position with the headlights
ON, the headlights remain on for about 20 minutes. However, if the driver’s door
is opened and closed, the headligh ...
Tire chains
Tire chains, if necessary, should be installed on the front wheels.
Be sure that the chains are installed in accordance with the manufacturer's instructions.
To minimize tire and chain wear, do ...
Vehicle identification number (VIN)
The vehicle identification number (VIN) is the number used in registering your
car and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the front pa ...