Hyundai Accent Manuals

Hyundai Accent: Replacement - Fluid. Repair procedures - Hydraulic System - Automatic Transaxle SystemHyundai Accent: Replacement

ATF of 6 speed automatic transaxle doesn’t need to be replaced. If the vehicle is used severely in business or personal use, replace ATF every 60,000 miles.
Severe usage is defined as
•
Driving in rough road (Bumpy, Gravel, Snowy, Unpaved road, etc)
•
Driving in mountain road, ascent/descent
•
Repetition of short distance driving
•
More than 50% operation in heavy city traffic during hot weather above 32°C(89.6°F) .
•
Police, Taxi, Commercial type operation or trailer towing, etc
1.
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.


Drain plug tightening torque:
38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

The gasket of the drain plug use new one.
2.
Fill the oil about 5 liters through eyebolt.
3.
Check the oil level.
(Refer to "Hydraulic system (Fluid)" in this group)

Service Adjustment Procedure
Oil level Check A check of ATF level is not normally required during scheduled services. If an oil leak is found, ...

Valve Body. Description and Operation
Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pr ...

See also:

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Installation
Side Impact Sensor • Do not turn the ignition switch ON and do not connect the battery c ...

Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com