Hyundai Accent Manuals

Hyundai Accent: Replacement - Transaxle Control Module (TCM). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM). Repair procedures / Replacement

1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A).
4.
Remove the TCM after removing the bolt and nut.
TCM installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side ...

Installation
1. Installation is reverse of removal. In the case of the vehicle equipped wi ...

See also:

Installation
• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

Engine Coolant Temperature Sensor (ECTS). Description and Operation
Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor th ...

Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil be used during cold weather. See section 8 for recommendations. If you aren't sure what weight oil you s ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com