1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the brake caliper mounting bolts , and then hold the brake
caliper assembly (B) with wire.
|
4. |
Remove the brake hose mounting bracket (A) & wheel speed sensor
(B) & bracket (C).
|
5. |
Remove driveshaft nut (A) from the front hub under applying the
brake.
|
6. |
Remove the tie rod end ball joint from the knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Loosen the strut mounting bolts and then remove the knuckle assembly
(A).
|
10. |
Install in the reverse order of removal.
|
Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Owner’s Handbook & Warranty
Information booklet in ...
Removal
Door Mirror Turn Signal Lamp
1.
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
2.
Remove ...
Adjustment
ETC module learning
procedure
When installing new ETC module or re-installing it, ETC module
learning procedure must be performed.
1.
Hold the ignition k ...