1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Remove the brake caliper mounting bolts, and then place the brake
caliper assembly (B) with wire.
|
4. |
Remove the brake hose mounting bracket (A) & wheel speed sensor
(B) & bracket (C).
|
5. |
Remove driveshaft nut (A) from the front hub under applying the
brake.
|
6. |
Remove the tie rod end ball joint from the knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Insert a pry bar (A) between the transaxle case and joint case,
and separate the drive shaft (B) from the transaxle case.
|
10. |
Install in the reverse order of removal.
|
Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Seat Heater Switch. Schematic Diagrams
Schematic Diagram
...
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...