Hyundai Accent: Seat Electrical

Installation

1. Install the BCM. 2. Install the crash pad lower panel. ...

Seat Heater. Components and Components Location

Components ...

See also:

Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Fuel Pressure Control Valve. Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve ...