Oil level Check |
A check of ATF level is not normally required during scheduled
services. If an oil leak is found, perform the oil level check procedure
after repairs are completed.
|
When checking the oil level, be careful not to enter dust, foreign
matters, etc. from fill hole.
|
1. |
Remove the eyebolt (A).
|
2. |
Add ATF SP-IV 700cc to the ATF injection hole.
|
3. |
Start the engine. (Don’t step on brake and accelerator simultaneously.
|
4. |
Confirm that the temperature of the A/T oil temperature sensor
is 50 ~ 60°C(122 ~ 140°F) with the GDS.
|
5. |
Shift the select lever slowly from “P” to “D”, then “D” to “P”
and repeat one more at idle.
|
6. |
Lift the vehicle, then remove the oil level plug (A) from the
valve body cover.
|
7. |
If the oil flows out of the overflow plug in thin steady stream,
the oil level is correct.
Then finish the procedure and tighten the oil plug.
|
8. |
Put down the vehicle with the lift and then tighten the eyebolt.
|
Engine Coolant Temperature
Sensor (ECTS). Description and Operation
Description
Engine Coolant Temperature Sensor (ECTS) is located in the
engine coolant passage of the cylinder head for detecting the engine coolant
temperature. The ECTS uses a thermistor th ...
Lubricants
Item
Specified lubricant
Quantity
Transaxle fluid
SK ATF SP-Ⅳ, MICHANG ATF SP-Ⅳ,
NOCA ATF SP-Ⅳ, Hyunda ...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...