Hyundai Accent: Accelerator Pedal. Repair procedures

Installation

1. Installation is reverse of removal. Filler-neck assembly bracket installation nut : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...

Removal

1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector ...

See also:

Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) po ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes. ...