Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly. Repair procedures / Installation

1.

Installation is reverse of removal.

Filler-neck assembly bracket installation nut :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-neck assembly installation screw :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Removal

1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler hose (A) ...

Accelerator Pedal. Repair procedures

...

See also:

TPMS Receiver. Repair procedures
Replacement 1. Disconnect the battery negative cable from the battery. 2. Remove faulty part and fit bracket assembly to new part. ...

Removal
Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted ...

Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com