Hyundai Accent: Accelerator Position Sensor
(APS). Repair proceduresInspection
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Turn the ignition switch ON.
|
| 3. |
Measure the output voltage of the APS 1 and 2 at
C.T and W.O.T.
|
Accelerator Position Sensor
(APS). Schematic Diagrams
Fuel Tank Pressure Sensor
(FTPS). Description and OperationRear combination light bulb replacement (4 Door)
(1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Side marker
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the sock ...
Removal
1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect
the connector.
...
Tire maintenance
In addition to proper inflation, correct wheel alignment helps to decrease tire
wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment.
When you have new tires instal ...