Hyundai Accent: Troubleshooting
Hyundai Accent RB (2010-2018) Service Manual / Body (Interior and Exterior) / General Information / Troubleshooting
Troubleshooting
|
Symptom |
Suspect Area |
Remedy |
|
Water leaks from sunroof |
Dirt accumulated in drain tube |
Clear dirt inside of drain |
|
Clogged drain tube |
Blow air into drain to remove dirt |
|
|
Broken or dislocated drain tube, defective or cracked clip |
Check tube installation and flange contact |
|
|
Deteriorated roof lid weatherstrip |
Replace |
|
|
Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
|
Wind noise around sunroof |
Loosen or deformed deflector, gaps in body work |
Retighten adjust or replace |
|
Sunroof lid makes a noise when move |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
|
Loosen guide rails and lid |
Retighten |
|
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
|
Incorrect engagement of motor pinion with drive cable |
Check for loosen motor installation and damaged pinion |
|
|
Decrease in motor`s clutch slipping force |
Adjust |
|
|
Increased sunroof sliding resistance or interference of sunroof with
drive cables, weatherstrip, etc. due to mal adjustment of sunroof |
Adjust or replace |
|
|
Noise in motor (clutch slipping noise from motor when sunroof is fully
opened or closed is not an unusual noise |
Incorrect engagement of motor pinion With drive cable |
Check pinion installation and Retighten motor |
|
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
|
Worn out or deformed drive cable |
Replace |
|
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
|
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
|
Defective door check assembly |
Correct or replace |
|
|
Door hinge requires grease |
Apply grease |
|
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
|
Incorrectly installed hood |
Adjust |
|
|
Incorrect hood bumper height |
Adjust |
|
|
Water leak through windshield end rear window |
Defective seal |
Fill with sealant |
|
Defective flange |
Correct |
Special Service Tools
Special Tools
Tool (Number and name)
Illustration
Use
09861-31100
Sealant cut-out tool
Cutting windshield sealant
( ...
Body Dimensions
...
See also:
Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remove the d ...
Impact sensing door unlock system
All doors will be automatically unlocked when the impact is delivered to impact
sensors while the ignition switch is ON. However, the doors may not be unlocked
if mechanical problems occur with th ...
Carry emergency equipment
Depending on the severity of the weather where you drive your car, you should
carry appropriate emergency equipment. Some of the items you may want to carry include
tire chains, tow straps or chai ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com