Hyundai Accent: Adjustment
How To Initialize Motor
|
1. |
Check that the glass has been installed.
| A. |
Finished height adjustment.
|
|
|
2. |
Push the down switch. (Keep on pushing the switch)
| A. |
The slide should move 5mm forward after 15 seconds.
|

|
|
3. |
After moving the slide 5mm forward, turn OFF the switch and push
the down switch (Keep on pushing the switch with continuous operation).
| A. |
If the operation above is correct, the sunroof will open
and close one time.
|
|
|
4. |
When the sunroof is completely closed, turn OFF the down switch.
The Inital Motor procedure in now completed.
|
When To Initialize The Motor
|
1. |
At the time of manufacture.
|
|
2. |
If the Initial setting is erased due to loss of power.
|
|
3. |
After using the manual handle.
|
Operating The Sunroof Emergency Handle
|
1. |
Use the sunroof emergency handle to close and open the sunroof
manually for the following case only:
| A. |
To close the sunroof before driving a vehicle in a rainy
day or on the highway if the sunroof cannot be closed due to
failure of the sunroof motor or controller.
|
|
|
2. |
Operating method
| B. |
Push the emergency handle up into the hexagonal drive
of the sunroof motor. You must push hard enough to disengage
the motor clutch; otherwise the emergency handle will slip due
to incomplete fit in the motor.
|
| C. |
After closing the sunroof, wiggle the handle back and
forth as you remove the tool from the motor, to ensure the motor
clutch reengages.
|
| D. |
A 5mm hex socket may be used in place of the emergency
handle, with a "Speeder" type handle.
|
|
• |
Do not use power tools to operate the sunroof.
|
|
• |
Damage to the components may occur.
|
|

|
Glass Replacement
•
Put on glove to protect your hands.
1.
...
Replacement
Outside Rear View Mirror Assembly Replacement
•
When prying with a flat-tip screwd ...
See also:
Components and Components Location
Components
1. Hands free call switch
2. Mic
3. Front left speaker
4. Front right speaker
5. Audio head unit (hands free control)
※ There is ...
Oil Pump. Description and Operation
Description
The oil pump is built-in as a single unit with the 26 brake chamber. Rotation
of the pump builds the hydraulic pressure needed for the lubrication of the
various parts of the tra ...
Specifications
Specifications
Items
Specifications
Rated voltage
DC 12V
Operating temperature range
-30°C ~ +80°C (-22 ~ +17 ...