Hyundai Accent Manuals

Hyundai Accent: Special Service Tools - General Information - Engine Control/Fuel SystemHyundai Accent: Special Service Tools

Special Service Tools

Item
Illustration
Application
Fuel Pressure Gauge
(09353-24100)

Measuring the fuel line pressure
Fuel Pressure Gauge Adapter
(09353-02100)

Connection between the high pressure fuel pump and the fuel feed line
Heated Oxygen Sensor Socket Wrench
(09392-2H100)

Removal and installation of the heated oxygen sensor
Torque Wrench Socket
(09314-3Q100) or
(09314-27130) (19mm)

Removal and installation of the high pressure fuel pipe
Injector Combustion Seal Guide & Sizing tool
(09353-2B000)

Installation of the injector combustion seal


Tightening Torques
Engine Control System Item kgf.m N.m lb-ft ECM installation bolt 1.0 ~ 1.2 9.8 ~ 11.8 7.2 ~ 8.7 ...

Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The ...

See also:

Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks. To be sure the trunk lid is securely fastened, always check by trying to pull it up again. WARNING The trunk lid s ...

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Installation
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Hyundai Accent Manuals

В© 2011-2025 Copyright www.hamanual.com