Hyundai Accent: Adjustment
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module
learning procedure must be performed.
| 1. |
Hold the ignition key or the start button at th IG
ON position during 5 seconds.
|
| 2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC
module learning procedure does not performed after replacing ETC module.
|
Installation
•
Install the component with the specified
torques.
•
...
Manifold Absolute Pressure
Sensor (MAPS). Description and Operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute pressure
of the surge tank and transfers the analog ...
See also:
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Parki ...
ETC (Electronic Throttle
Control) System. Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Installation
•
Be sure to check the low pressure fuel hose
quick-connector (A) is completely connected to ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com