Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Canister Close Valve (CCV). Repair procedures / Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the CCV connector.

3.	Measure resistance between the CCV terminal 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.	Disconnect the vapor hose connected with the canister from the CCV.

6.	Connect a vacuum pump to the nipple.

7.	Ground the CCV control line and apply battery voltage to the CCV power supply line.

8.

Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Canister Close Valve (CCV). Repair procedures

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...

See also:

Replacement
1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Snowy or icy conditions
To drive your vehicle in deep snow, it may be necessary to use snow tires or to install tire chains on your tires. If snow tires are needed, it is necessary to select tires equivalent in size and ...

Air bag - advanced supplemental restraint system
(1) Driver’s front air bag (2) Passenger’s front air bag (3) Side impact air bag (4) Curtain air bag WARNING Even in vehicles with air bags, you and your passengers must always wear the ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com