Hyundai Accent: Installation

Removal

1. Remove the mounting bolt and disconnect the horn connector, then remove the horn (A). ...

Adjustment

Operate the horn, and adjust the tone to a suitable level by turning the adjusting screw. After adjustment, apply a small amo ...

See also:

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body ...

Inhibitor Switch. Schematic Diagrams
Circuit Diagram ...