Hyundai Accent Manuals

Hyundai Accent: Installation - Canister Close Valve (CCV). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Installation is reverse of removal.

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...

Fuel Delivery System
...

See also:

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...

Replacement
1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Removal
• Take care not to scratch the center fascia panel and related parts. ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com