Hyundai Accent Manuals

Hyundai Accent: Installation - Thermostat. Repair procedures - Cooling System - Engine Mechanical SystemHyundai Accent: Installation

1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

3.
Fill with engine coolant.
4.
Start engine and check for leaks.

Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. ...

Thermostat. Troubleshooting
Troubleshooting Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket ...

See also:

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

Components and Components Location
Components Location 1. Sub frame 2. Drive shaft 3. Lower arm 4. Strut assembly 5. Steering gearbox 6. Stabilizer bar ...

Interior F ( 5Door )
Seatbelt height adjust upper mounting hole (Ø15) Seatbelt height adjust lower mounting hole (Ø15) ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com