Hyundai Accent Manuals

Hyundai Accent: Installation - Output Speed Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor. Repair procedures / Installation

1.
Installation is the reverse of removal.
•
The gasket of the valve body cover gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)

•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation
Description Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque c ...

See also:

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the CVVT oil control valve connector (A). ...

Heated seats
With the engine running, use the adjustment knob to switch on and select the level of heating required: 0 : Off. 1 : Low. 2 : Medium. 3 : High. The front seats can be heated individually. Do not u ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com