Hyundai Accent: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
| 1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
| 2. |
Remove the under cover (A).
|
| 3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
| 4. |
Remove the valve body cover (A) and eyebolt (B).
|
| 5. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
| 6. |
Remove the solenoid valve (B) after removing the solenoid support
(A).
|
Inspection
InstallationReplacement
1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A ...
Seat Heater. Repair procedures
Inspection
Driver seat and Passenger seat
1.
Check for continuity and measure the resistance between terminals.
[Cushion]
...
Removal
Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper (A) and lower (B) shrouds aft ...