Hyundai Accent Manuals

Hyundai Accent: Disassembly - Front Hub / Knuckle. Repair procedures - Front Axle Assembly - Driveshaft and axleHyundai Accent: Disassembly

1.
Remove the snap ring (A).

2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the front knuckle assembly (A) on press.
(2)
Lay a suitable adapter (B) upon the hub assembly shaft.
(3)
Remove the hub assembly (C) from the knuckle assembly (A) by using press.

3.
Remove the hub bearing inner race from the hub assembly.
(1)
Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
(2)
Lay the hub assembly and tool (A) upon a suitable adapter (B).
(3)
Lay a suitable adapter (C) upon the hub assembly shaft.
(4)
Remove the hub bearing inner race (D) from the hub assembly by using press.

4.
Remove the dust cover (A).

5.
Remove the hub bearing outer race from the knuckle assembly.
(1)
Lay the hub assembly (A) upon a suitable adapter (B).
(2)
Lay a suitable adapter (C) upon the hub bearing outer race.
(3)
Remove the hub bearing outer race from the knuckle assembly by using press.

6.
Replace hub bearing with a new one.

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Reassembly
1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

See also:

To decrease the cruising speed
Follow either of these procedures: Push the SET- switch and hold it. Your vehicle will gradually slow down. Release the switch at the speed you want to maintain. Push the SET- switch and re ...

Side Body D ( 5Door )
Side outer panel notch Side outer panel notch Side outer panel notch ...

Repair procedures
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Tr ...

Hyundai Accent Manuals

В© 2011-2025 Copyright www.hamanual.com