Hyundai Accent Manuals

Hyundai Accent: Reassembly - Front Hub / Knuckle. Repair procedures - Front Axle Assembly - Driveshaft and axleHyundai Accent: Reassembly

Hyundai Accent RB (2010-2018) Service Manual / Driveshaft and axle / Front Axle Assembly / Front Hub / Knuckle. Repair procedures / Reassembly

1.
Install the hub bearing to the knuckle assembly.
(1)
Lay the knuckle assembly (A) on press.
(2)
Lay a new hub bearing upon the knuckle assembly (A).
(3)
Lay a suitable adapter (B) upon the hub bearing.
(4)
Install the hub bearing to the knuckle assembly by using press.

-
Do not press against the inner race of the hub bearing because that can cause damage to the bearing assembly.
-
Always use a new wheel bearing assembly.
2.
Install the dust cover (A).
3.
Install the hub assembly to the knuckle assembly.
(1)
Lay the hub assembly (A) upon a suitable adapter (B).
(2)
Lay the knuckle assembly (C) upon the hub assembly (A).
(3)
Lay a suitable adapter (D) upon the hub bearing.
(4)
Install the hub assembly (A) to the knuckle assembly (C) by using press.

Do not press against the inner race of the hub bearing because that can cause damage to the bearing assembly.
4.
Install the snap ring (A).

Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the ...

Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the brake disc for scoring and damage. 3. C ...

See also:

Circuit Diagram (2)
...

Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

Removal
1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the rear sea ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com