Hyundai Accent Manuals

Hyundai Accent: Replacement - TPMS Sensor. Repair procedures - Tire Pressure Monitoring System - Suspension SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor. Repair procedures / Replacement

Repair tire after using the Tire Mobility Kit (TMK)
When the TPMS warning lamp OFF
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.

3.
Install the TPMS sensor to the new tire.
4.
Check that the normal operation of TPMS system.
When the TPMS warning lamp ON
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.

3.
Install the TPMS sensor to the new tire.
4.
Check the tire pressure using the electrical tire pressure gauge.
5.
Check the tire pressure of TPMS sensor using the GDS
6.
If the difference between two checked pressures in the above is not more than 2 psi, TPMS sensor is normal. Reinstall it to new tire.
7.
If the difference between two checked pressures in the above is more than 2 psi, TPMS sensor is abnormal. Install new TPMS sensor to new tire.
8.
Check that the normal operation of TPMS system.

Removal
Handle the sensor with care. 1. Remove the tire. (Refer to "Tire Removal") ...

Installation
Sensor Fit • Handle the sensor with care. • ...

See also:

Trunk Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • ...

Inhibitor Switch. Specifications
Specifications ▷ Type: Combination of output signals from 4 terminals Power supply (V) 12 Output type Combination of output signals ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com