Hyundai Accent: Removal
Side Impact Sensor
| 1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 2. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
| 3. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
| 4. |
Disconnect the side impact sensor connector (A).
|
| 5. |
Loosen the side impact sensor mounting bolt (B) and remove the
side impact sensor.
|
Installation
Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect
the battery c ...
See also:
Room Lamp. Repair procedures
Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the
room lamp connector (A).
...
Installation
Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect
the battery c ...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com