Hyundai Accent Manuals

Hyundai Accent: Installation - Seat Belt Pretensioner (BPT). Repair procedures - Seat Belt Pretensioner - Restraint (Depowered)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT). Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with mounting bolts (B, C).
Tightening torque [Bolt B]:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (A).
5.
Install the upper anchor bolts.
Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the following parts.
(Refer to the Body group - "Interior trim")
A.
Center pillar trim
B.
Door scuff trim
7.
Install the lower anchor bolts.
Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
8.
Reconnect the battery negative cable.
9.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the lower anchor bolt. ...

Restraint (Advanced)
...

See also:

Installation
• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

Inspection
Rotor 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the s ...

Front Body B ( 4Door )
Hood hinge mounting hole (Ø10) Fender apron upper member tooling hole (Ø6.6) Cowl under ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com