Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / SRS Control Module (SRSCM). Repair procedures / Removal

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Remove the floor console. (Refer to the Body group - "Console")

4.	Remove the rear heating joint duct (A).

5.	Pull up the lock, of the SRSCM connector, the disconnect the connector (A and B).

6.	Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove the SRSCM.

SRS Control Module (SRSCM). Repair procedures

...

Installation

1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

See also:

In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you h ...

Removal
1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing thd tube (B) ...

Climate control air filter
The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system. If ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com