Hyundai Accent: Brake System

Installation

1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least three minutes. ...

General Information

...

See also:

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Rear Torsion Beam Axle. Repair procedures
Replacement [Disc Type] 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...