Hyundai Accent Manuals

Hyundai Accent: Installation - Anchor Pretensioner (APT). Repair procedures - Seat Belt Pretensioner - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Seat Belt Pretensioner / Anchor Pretensioner (APT). Repair procedures / Installation

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
3.
Install the anchor pretensioner with mounting bolt.
Tightening torque :
39.2 ~ 53.9 N.m(4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Connect the anchor pretensioner connector.
5.
Install the following parts.
(Refer to the Body group - "Interior trim")
A.
Center pillar trim
B.
Door scuff trim
6.
Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected in properly.
7.
Reconnect the battery negative cable.
8.
After installing the anchor pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the seat belt after pushing ...

Brake System
...

See also:

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A) after disconnecting the trip switch connector(B). ...

Inspection
1. Check the coil spring for crack and deformation. 2. Check the coil spring pad for damage and deformation. ...

Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com