Hyundai Accent: Cylinder Head Assembly

Installation

1. Dowel pin of crankshaft should be positioned at 3° in relation to vertical center line. 2. Align the TDC marks (A) of the CVVT ...

Cylinder Head. Components and Components Location

Components 1. Cylinder head cover 2. Cylinder head cover gasket 3. Cylinder head assembly 4. Cylinder head gasket 5. Camshaft position sensor 6. Camshaft bea ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And E ...

Inspection
Armature 1. Remove the starter. 2. Disassemble the starter as shown at the beginning of this procedure. 3 ...

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...