Hyundai Accent: Hazard warning flasher
Fourth generation RB (2010–present) / Hyundai Accent 2010-2019 Owners Manual / What to do in an emergency / Road warning / Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
- The hazard warning flasher operates whether your vehicle is running or not.
- The turn signals do not work when the hazard flasher is on.
- Care must be taken when using the hazard warning flasher while the vehicle is being towed.
Road warning
...
In case of an emergency while driving
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place.
If you h ...
See also:
Repair procedures
Compession Pressure Inspection
If the there is lack of power, excessive oil consumption
or poor fuel economy, measure the comp ...
Inspection
Speed Operation Check
1.
Remove the connector (A) from the wiper motor.
1. -
2. IGN+
3. Parking
4. High
5. GND
...
Inspection
1.
Immerse the thermostat in water and gradually heat
the water.
2.
Check the valve opening temperature.
...