Hyundai Accent Manuals

Hyundai Accent: Inspection - Water pump. Repair procedures - Cooling System - Engine Mechanical SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Cooling System / Water pump. Repair procedures / Inspection

1.
Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.
3.
Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly and gasket.
A small amount of “weeping” from the bleed hole is normal.

Removal and Installation
Water Pump 1. Drain engine coolant. System is under high pressure ...

Water pump. Troubleshooting
Troubleshooting Water Pump Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole ...

See also:

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Control System Composition
Fault Diagnosis Features a fail-safe mechanism that prevents dangerous situations from developing in the event of a transaxle failure. The limp home mode engages if the transaxle mal ...

Installation
Side Impact Sensor • Do not turn the ignition switch ON and do not connect the battery c ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com