Hyundai Accent: Inspection
| 1. |
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
|
| 2. |
Remove the battery and check voltage if the red light doesn't
flicker.
|
| 3. |
Insert the battery (A) into the tester (09954-2p100).
|
| 4. |
Push the test button and If "0.00" is displayed on screen, it
means that the battery voltage is 2V or less.
|
| 5. |
If "L" is displayed on screen, it means that the battery is low
power and it needs to replace.
|
| 6. |
To prevent the discharge of electricity, turn the tester power
off.
|
| 7. |
Replace the transmitter battery with a new one, if voltage is
low power then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times.
|
| 8. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors.
|
| 9. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, replace the transmitter.
|
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
See also:
Accelerator Position Sensor
(APS). Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator
pedal module and detects the rotation angle of the accelerator pedal. The APS
is one of the most important senso ...
Cleaning
1.
Make sure the ignition switch and all accessories
are in the OFF position.
2.
Disconnect the battery cables (negative first).
...
Installation
•
Do not spill brake fluid on the vehicle: it may damage
the paint; if brake fluid does conta ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com