Hyundai Accent Manuals

Hyundai Accent: Inspection - Front Wiper Motor. Repair 
procedures - Windshield Wiper/Washer - Body Electrical SystemHyundai Accent: Inspection

Speed Operation Check
1.
Remove the connector (A) from the wiper motor.
1. -
2. IGN+
3. Parking
4. High
5. GND
6. Low

2.
Attach the positive (+) lead from the battery to terminal 6 and the negative (-) lead to terminal 5.
3.
Check that the motor operates at low speed.
4.
Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 5.
5.
Check that the motor operates at high speed.
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.

Installation
1. Install the wiper motor. 2. Install the crank arm. 3. Install the lower and upper linkage to the wiper motor ...

Front Washer Motor. Repair procedures
...

See also:

Troubleshooting
Troubleshooting Symptom Suspected area Repairment Pressing power switch does not turn on system Radio receiver power source circuit ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.5, 1.42 ~ 7.82) ...

Inspection
Connecting Rod And Crankshaft 1. Check the connecting rod end play. Using feeler gauge, measure the end play while moving the connecting rod back and f ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com