Hyundai Accent: Inspection
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
| 3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
| 4. |
If they are abnormal, replace the washer motor.
Connector No.1 : Windshield washer(+),
2 : Ground
|
Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
See also:
Component(1)
<Installation order : A→B→C→D>
1. Steering column shaft
2. Lighting switch
3. Wiper and washer switch
4. Screw
5. Clock spring
...
Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14
(0.1 ~ 5.5, 1.42 ~ 7.82)
...
If engine turns over normally but does not start
1. Check fuel level.
2. With the ignition switch in the LOCK position, check all connectors at ignition
coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the engine sti ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com