Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor. Repair procedures / Removal

-	When servicing the washer pump, be careful not to damage the washer pump seal.

-	Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper. (Refer to the BD group - "Front bumper")

3.	Remove the washer hose and disconnect the washer motor connector (A).

4.	Remove the washer reservoir (A) after removing 2 bolts.

Inspection

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

Installation

1. Install the washer reservoir. Before installing the pump motor, check the f ...

See also:

Emergency towing
If towing is necessary, we recommend you to have it done by an authorized Hyundai dealer or a commercial tow truck service. If towing service is not available in an emergency, your vehicle may be ...

Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorma ...

Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative impact on the air conditioning system. Therefore, if abnormal operation i ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com