Hyundai Accent Manuals

Hyundai Accent: Inspection - Thermostat. Repair procedures - Cooling System - Engine Mechanical SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Cooling System / Thermostat. Repair procedures / Inspection

1.
Immerse the thermostat in water and gradually heat the water.
2.
Check the valve opening temperature.
Valve opening temperature : 82±1.5°C (179.6±2.7°F)
Full opening temperature : 95°C (203°F)
If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.
Valve lift : 8mm(0.3in) or more at 95°C (203°F)
If the valve lift is not as specified, replace the thermostat.

Removal
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. 1. ...

Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting ( ...

See also:

Inspection
[Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. ...

Manifold Absolute Pressure Sensor (MAPS). Description and Operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog ...

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com